In the Civ3 edit help, i read you can add units in debug mode. Yet i don't know how to activate debug mode. Can anyone please help? Or can anyone explain how to add units to a Scenario?

Debug mode is different (in game). Use Shift-F1 to add units. However, if you try to play the save, it will always be in debug mode. In the editor, click the shield and select the current player. You'll see 2 new icons light up. Those are cities and units.

i tried adding units with shift-F1 but that didn't work

To activate debug mode, open a bix file, go in Scenarion/Scenario Properties and check the "Debug Mode" checkbox, it's just beside the barbarian options. Then start a game with that bix file. Simple.

fi you play debug mode your nation will be called DEBUG and you will see the whole map from the start (no fog of war)

ok, thanks for the help

I think I'll have to make a tool to toggle a save between normal and debug.

Originally posted by warpstorm
I think I'll have to make a tool to toggle a save between normal and debug.

You're just too cool, Warpstorm --saying it as if to merely wave a magic wand. :)

Well, I made a tool that toggled the debug flags in the BICX section of the save. Unfortunately, apparently this isn't what controls whether a run is a debug run or not once it's a save. :( There are a lot of other changes (1000 more), many of them in areas of the file that I have never seen documented. This may have to wait till I get a little bit more info :(