The Flakpanzer 38(t) was designed around the chassis of the LT-38, a pre-war Czech design, which following the German occupation was produced for the Wehrmacht as the Panzer 38(t) until it was no longer effective.
As the vehicle used the Ausf M chassis, the engine was located near the middle of the vehicle, and the armament was placed at the rear in a specially designed armoured section. The superstructure could fold down to allow 360-degree traverse at low elevation.
Including the single prototype, 141 Flakpanzer 38(t)s were built from November 1943 to February 1944, entering service in 1944.
The file contains the unit and pcx files. Model is not my own creation. Wyrmshadow helped with the animation files. I merely put the pieces together and cleaned up the model for CivIII and added some what if pieces. A big thanks to everyone that helped out!
As the vehicle used the Ausf M chassis, the engine was located near the middle of the vehicle, and the armament was placed at the rear in a specially designed armoured section. The superstructure could fold down to allow 360-degree traverse at low elevation.
Including the single prototype, 141 Flakpanzer 38(t)s were built from November 1943 to February 1944, entering service in 1944.
The file contains the unit and pcx files. Model is not my own creation. Wyrmshadow helped with the animation files. I merely put the pieces together and cleaned up the model for CivIII and added some what if pieces. A big thanks to everyone that helped out!
