Simple Question (I hope ...)

[Ozymandias]

How does one load a partially completed PTW mod into Conquests and keep editting it? -- My attempts have led to graphics disasters and I cannot utilize the new units and civs.

(Yes, I know this should perhaps be in the main C&C forum, and it is -- I'm just casting as wide a net as possible as it's both vexing and not obvious.)

Thanks,

Oz

 

[dreadknought]

I dont think you can do that but the mod can be finished and played from the play the world disc even with conquests loaded.

 

[SuperBeaverInc.]

Just create a new Conquest map. Then click File and Import. Select what you want to be transfered into that file, and select the file that has all the info in it. It should then transfer the PTW mod into Conquests file, allowing you to use the new C3C units and improvemnts

 

[Ozymandias]

Originally posted by SuperBeaverInc.
Just create a new Conquest map. Then click File and Import. Select what you want to be transfered into that file, and select the file that has all the info in it. It should then transfer the PTW mod into Conquests file, allowing you to use the new C3C units and improvemnts

(1) Actually the map ITSELF imports just fine. The graphics errors I seem to be getting stem -- I think! -- from my inability to figure out how to get Conquests to read the custom resources.pcx and units32 the mod uses (without over-writing them in the Conquests directory itself).

(2) If I cannot get to the new Civs etc without trashing the map then frankly I might as well ignore Conquests and just finish the mod in PTW.

Thanks,

Oz